Owner’s Manual
Adjust the Chain Step Description 1 Loosen axle bolt. 2 To tighten chain, turn the 8mm nut on the eyebolt counter clockwise 3 To loosen the chain,
Adjust the Brake Step Description Tighten Brake Loosen nut; loosen the 8mm nut and pull the cable back and slide the arm forward, once you have
Troubleshooting Chart Problem Cause Solution The power light by the on/off switch does not light up when the scooter is turned on? 1. Battery is dis
YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CO
Warranty. Rad2Go warrants each new Rad2Go product for thirty (30) days according to the following terms. This warranty extends to the original reta
Rad2Go Electric Scooter Warranty This Warranty Registration is to be completed by the dealer or customer at the time of purchase and submitted to Rad
nature and any circumstances leading to the problem. A service technician will contact you with specific instructions to ensure that you receive the
17 BY SIGNING BELOW YOU ARE AGREEING TO HAVE ANY DISPUTES ARISING OUT OF THE MATTER INCLUDING IN THE “ARBITRATION OF DISPUTES” PROVISION DECIDED BY N
Important Note To Parents About Safe Riding Your child's safety will depend on your commitment to always provide a safe riding environment and a
Safety Precautions 1. Review all the instructions carefully before operations. 2. Follow all rules and regulations in your area for operating an el
List of Parts Handle Bar Grips Front Fork Front Wheel Power Switch Kickstand Skid Plate Rear Wheel Deck Quick Release Hand Brake Throttle Controlle
Assembly Instructions 1. Carefully take your scooter out of the box. 2. Assemble the Handle Bar. a. Remove the bolt from the base of the H
c. Unscrew the bolts on the ‘T’ of the Handle Bar and place the Grips into the Handle Bar and screw in the bolts to secure the grips. 3. Turn the
6. Charging 1. Power Switch must be in the ‘off’ position. 2. Do not plug the charger into the outlet first, for safety reasons plug the charger c
Change the Rear Tire • Tools Required: - Phillips screwdriver - 8mm wrench - 2 x 16mm wrench Step Description 1 Ensure power switch is in the
Change the Motor Step Description 1 Remove the deck. 2 Disconnect the wires, by loosening the bolts. 3 Unscrew the 2 bolts that secure the motor, a
Commentaires sur ces manuels